[Arm-netbook] Project status / 3D printing of resin cases?
rekado at elephly.net
Wed Aug 15 11:56:36 BST 2018
Hi David Niklas,
> As for my status, (since you did ask why the ML was silent), I'm hand
> soldering an eDP connector. It is going poorly as the pins are so small
> that I had to buy a set of 20x mag glasses.
Have you tried drag soldering? You would coat the pins and pads in
thick flux paste and drag a small ball of solder with a large chisel tip
iron across the pins. Any unwanted bridges can be destroyed by heating
More information about the arm-netbook