[Arm-netbook] EOMA68-A20 interface redesign

[Luke Kenneth Casson Leighton]

same place as last time.  please arrange your friend to run and
generate gerbers i am very busy

On Mon, Jun 2, 2014 at 7:51 AM, joem <joem at martindale-electric.co.uk> wrote:
> On Sun, 2014-06-01 at 18:22 +0100, Luke Kenneth Casson Leighton wrote:
>> ok joe i've completed the routing, SATA was a bitch i had to put in
>> about 4 sets of VIAs and use the POWER layer for a short duration
>> around the SoC's BGA grid, but it's done.  the big parallel groups,
>> RGB/TTL, HDMI, Ethernet, NAND and SD/MMC all got subtly shuffled and
>> shifted but mr xul has them all grouped veery neatly together, so i
>> have confidence that those subtle shifts would have added roughly the
>> same length to each.
>>
>> btw i chickened out of adding a RESET/POWER line by taking over one of
>> the 5V lines - i feel it's too complicated to put in right now.
>>
>> i'm happy for someone else to check this over - i will upload it for
>> ftp download, can you let your friend know?  also i will contact the
>> PCB factory we have been using, their guy patrick is extremely
>> competent, he has been helping do verification of the PCBs we have
>> been doing and he has helped pick up errors in the past.
>
> Upload the gerbers and schematic and point. I download,
> check and get a cost. The 2GB RAM is a winner.
> (It will need a new script.fex to get it going I assume?)
>
> _______________________________________________
> arm-netbook mailing list arm-netbook at lists.phcomp.co.uk
> http://lists.phcomp.co.uk/mailman/listinfo/arm-netbook
> Send large attachments to arm-netbook at files.phcomp.co.uk