[Arm-netbook] microdesktop casework as DXF files for laser-cutting
Mark Van den Borre
mark at lusis.eu
Thu Mar 30 23:02:36 BST 2017
2017-03-30 23:58 GMT+02:00 Hendrik Boom <hendrik at topoi.pooq.com>:
> On Thu, Mar 30, 2017 at 10:39:01AM -1000, Tor, the Marqueteur wrote:
> > Thickness is where we lose all plywood moisture stability with the
> > stacked option. 8 layers, 3mm thick = ~24mm thick, or a little less than
> > 1". As I posted earlier, between someone living in a desert, and someone
> > living in a wet tropical area, the latter may have a case almost 1/16" or
> > 1.5mm thicker than the desert person.
> Is there another material we could use that can be laser-cut but
> doesn't have problems with dimensional stability?
Acrylic is the obvious answer to this question. Though I'm quite sure the
plywood's potential z dimensional stability issues can be worked around...
> -- hendrik
> arm-netbook mailing list arm-netbook at lists.phcomp.co.uk
> Send large attachments to arm-netbook at files.phcomp.co.uk
full service b2b laser cutting
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the arm-netbook