Hello Hendrik,

2017-03-30 23:58 GMT+02:00 Hendrik Boom <hendrik@topoi.pooq.com>:
On Thu, Mar 30, 2017 at 10:39:01AM -1000, Tor, the Marqueteur wrote:
>
> Thickness is where we lose all plywood moisture stability with the
> stacked option.  8 layers, 3mm thick = ~24mm thick, or a little less than
> 1".  As I posted earlier, between someone living in a desert, and someone
> living in a wet tropical area, the latter may have a case almost 1/16" or
> 1.5mm thicker than the desert person.

Is there another material we could use that can be laser-cut but
doesn't have problems with dimensional stability?
Acrylic is the obvious answer to this question. Though I'm quite sure the plywood's potential z dimensional stability issues can be worked around...

Kind regards,

Mark

-- hendrik

_______________________________________________
arm-netbook mailing list arm-netbook@lists.phcomp.co.uk
http://lists.phcomp.co.uk/mailman/listinfo/arm-netbook
Send large attachments to arm-netbook@files.phcomp.co.uk



--
--
http://lusis.eu
full service b2b laser cutting