[Arm-netbook] Micro desktop corner design

Luke Kenneth Casson Leighton lkcl at lkcl.net
Tue May 30 09:45:56 BST 2017


On Tue, May 30, 2017 at 5:09 AM, Tor, the Marqueteur
<Marqueteur at fineartmarquetry.com> wrote:
> On 29/05/17 16:56, Luke Kenneth Casson Leighton wrote:
> ...snip...
>>> 1.  Am I right that the front right corner actually only needs a single
>>> wide dado on the inside face for the eject button?
>>
>>  yes.
>>
>>> 2. Do any of the components on the other three corners need cutouts,
>>
>>  no.
>>
>>> or  are they back just far enough to clear?
>>
>>  yes.
>
> Then, presuming I can find a router bit within tolerance for the height
> of the eject button, it looks like I could do this design as is for the
> corners.

 if i thin down the parts on the inner edge i could potentially do
away with the need for the eject button inset entirely.

 i also want to bring out the PCB cut through to the front so that you
can do a straight-through cut with a router @ around 1.8 to 2.0mm.

l.



More information about the arm-netbook mailing list