[Arm-netbook] EOMA68-A20 2.7.4 pre-production prototypes received and working

[mike.valk at gmail.com]

2017-06-16 8:54 GMT+02:00 Luke Kenneth Casson Leighton <lkcl at lkcl.net>:

> On Fri, Jun 16, 2017 at 7:51 AM, mike.valk at gmail.com
> <mike.valk at gmail.com> wrote:
> > . Use smaller width tracks.
>  can't.
>
Was afraid of that

>
> > . Cut the pads tight a little shorter and place the via's to the right
> > creating a bottleneck but stil far enough from the edge
>
>  possible.
>
> > . The above but to the left, via's in the middle.
>
>  possible but risky.
>

Depends on how near to can get to left hand pads or the egde on the right
and were the pads in the connector have most tolerance.

Speaking of near the edge. The tracks on the board seem awfully close the
boards cutoff edge. Doesn't that create a problem for cutting them out?