[Arm-netbook] Injection Molding Cost

[Luke Kenneth Casson Leighton]

---
crowd-funded eco-conscious hardware: https://www.crowdsupply.com/eoma68


On Sat, Aug 5, 2017 at 12:47 AM, Bill Kontos <vkontogpls at gmail.com> wrote:
> Hi, I remember luke mentioning in the past that injection molding
> would be too expensive for such a low-volume project. However I found
> this project from crowd supply that is using molds for production on a
> total of ~3800 pledges

 with half a million dollars, yes.

> The numbers don't make any sense given the ~100k cost luke has
> mentioned in the past( the 2 keyboard halves have different designs).

 with only about 4 small part.... not 35.

l.