[Arm-netbook] first prototype microdesktop casework

[Luke Kenneth Casson Leighton]

On Sat, Apr 29, 2017 at 6:08 AM, Luke Kenneth Casson Leighton
<lkcl at lkcl.net> wrote:
> http://rhombus-tech.net/community_ideas/micro_desktop/news/

 ok, ouch, onto the fourth revision of the corner-pieces already, and
some minor changes to the plywood are needed as well.  this really
would have been awkward if someone else did it.

 the anycubic 3d printer is holding up well.  the higher-quality PLA
from the company i found on aliexpress seems reasonable so far (the
"standard" quality definitely isn't: it literally crumbles under
pressure).

 i'm going to have to go with 2 bolts through the base to hold the PCB
(and the card rails) in place: one isn't enough.  assembly's...
awkward.  it's going to have to go out as a kit.

 getting there.

l.