[Arm-netbook] EOMA68-A20 usb fel-boot and u-boot upload (no GPL-violating allwinner boot0 or boot1 involved)
luke.leighton
luke.leighton at gmail.com
Sat Jun 1 00:49:55 BST 2013
http://hands.com/~lkcl/eoma/eoma68-a20-uboot.patch
mess but it works. A20 is more like SUN5I. kernel doesn't boot yet,
possibly due to watchdog timer issue, TBD tomorrow.
l.
-------------
U-Boot SPL 2013.04-06937-g4a60715-dirty (Jun 01 2013 - 00:35:33)
Board: EOMA68_A20
DRAM:dramc_init pre setup clock
dramc_init pre disable pad power
dramc_init pre ddr3 reset
dramc_init pre set drive
dramc_init clock off
post select dram, csel = 0x86c9883
dramc_init clock pre itm disable
dramc_init clock pre enable dll0
dramc_init configure external dram
dramc_init external dram reg written
dramc_init set impedance
dramc_init clock on
dramc_init wait for ccr
dramc_init enable dllx
dramc_init set iocr
dramc_init set refresh period
dramc_init set timings
dramc_init set mode
dramc_init set dqs
dramc_init reset dram
dramc_init scan read pipe
dramc_init read pipe: 0
dramc_init configure hostport
dramc_init configured hostport, getting ramsize
dramc_init got ramsize 1073741824
1024MB
U-Boot 2013.04-06937-g4a60715-dirty (Jun 01 2013 - 00:35:33) Allwinner Technoloy
CPU: SUNXI Family
Board: EOMA68_A20
I2C: ready
DRAM: 1 GiB
MMC: SUNXI SD/MMC: 0
MMC Device 3 not found
No MMC card found
Using default environment
In: serial
Out: serial
Err: serial
Net: wemac
Hit any key to stop autoboot: 0
reading uEnv.txt
188 bytes read in 10 ms (17.6 KiB/s)
Loaded environment from uEnv.txt
reading boot.scr
579 bytes read in 3 ms (188.5 KiB/s)
Jumping to boot.scr
## Executing script at 44000000
Failed to mount ext2 filesystem...
** Unrecognized filesystem type **
reading script.bin
43084 bytes read in 7 ms (5.9 MiB/s)
reading uImage
3355592 bytes read in 171 ms (18.7 MiB/s)
## Booting kernel from Legacy Image at 48000000 ...
Image Name: Linux-3.3.0
Created: 2013-05-29 20:27:05 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3355528 Bytes = 3.2 MiB
Load Address: 40008000
Entry Point: 40008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Error: unrecognized/unsupported machine ID (r1 = 0x00001008).
Available machine support:
ID (hex) NAME
00000f35 sun7i
Please check your kernel config and/or bootloader.
More information about the arm-netbook
mailing list