[Arm-netbook] SHIPPING!: EOMA-68 Micro Engineering Boards

[luke.leighton]

On Thu, Aug 8, 2013 at 7:00 AM, Christopher Thomas
<christopher at firemothindustries.com> wrote:
> So, I'm still going over the schematics and datasheets, and it's super late
> (0100 CST), but as far as R2/R3, I was just going off the Schematic that was
> sent to me. But looking at it again, it's possible I misunderstood, but
> isn't R3 is supposed to be connected between R2 and pin 11 "ETH
> FB(Feedback?)" ? Also, isn't Pin 11 and Pin 1 supposed to receive 1.9V?

 i don't know!!  my understanding is that 1 and 11 are tied together,
1.9v is only for gigabit - 10/100 is slightly different.  i'll do some
measurements this evening.

 what's the part numbers (links preferably, or did you upload all the
datasheets?) if not could you edit
http://rhombus-tech.net/community_ideas/micro_engineering_board/ and
put them on there?

l.