[Arm-netbook] A10 EOMA68 boot progress

[luke.leighton]

On Tue, Apr 30, 2013 at 2:19 AM, Piyush Verma <piyush.pv at gmail.com> wrote:
>
>
> On Tue, Apr 30, 2013 at 6:29 AM, luke.leighton <luke.leighton at gmail.com>
> wrote:
>>
>> ok so i have a first boot with android preloaded, it's in chinese so i
>> have no idea what it says :)  i'm attempting to put a USB hub onto
>> pins 30 and 64, and using a *male* USB plug with just the 5V and GND
>> lines, connected to pins 29,63 and 33,67 respectively.  it's not
>> _quite_ working out :)  this is possibly because i've not connected
>> the shielding on either cable to GND, which i probably should do.
>
>
> USB is very high frequency so proper connection and good quality wire is
> important.

 ack

>
>>
>>
>> i say "not quite working out" - android boots, comes up on the HDMI
>> monitor.  so i have no idea if the USB Host cable i've done is not
>> working due to the build of android or not.
>
>
> Have you checked pin assignment of USB in script.bin

 we cannot get access to script.bin yet.

> No detection of USB kernel side ? What dmesg|tail says after plugging hub ?

 we cannot see what the kernel config is, nor run dmesg|tail.  there
is no login access of any kind.

 later this evening i will wire up the UART0.  if that fails i will
start with the USB-OTG in boot-loader mode.

 l.