[Arm-netbook] eoma68 router pcb

[joem]

right - bit of a marathon session last night and most of the routing
is done.  nothing like as complex as the flying squirrel - no embedded
controller, plenty of space (double-sided), it's pretty much a breeze.

questions:

1) joe as this is GPLv3+ open hardware does your offer to PCB-print
and populate it still stand, even though i've had to use PADS? (i
don't have the expertise yet to not not use KiCAD because it lacks
comprehensive design rules).

2) is there anyone who would like to have a go at ordering a rev1
board just for the sheer heck of it?

3) if not, and there is something missing, what would encourage you to
splash out on a completely experimental PCB in the way of functions or
interfaces? (yes i have to look up POE, see if i can fit it on
somewhere).

--
If its open, then upload somewhere and post link with all the datasheets,
cad files and some PDFs of the board and circuits - if it looks
doable, I'll take a shot at it in parallel with any others.
Most likely a kicad version will get drawn and laid out as well
to try and get it all into kicad format so that everyone can use it.