On 29/03/17 17:34, Normand Chamberland wrote:
Hello,
Thanks Mark. Just to give some context to these files:
- There are 11 lasercut wood pieces. That's a lot. Is the layered design
definitive (I guess that's what the backers will expect since that's what's shown on Crowd Supply), or could this be discarded in favour of a new design optimizing fabrication? A more classic box with dovetail joints may be less expensive, and allow more control on the fitting of the board. Something akin to https://images-na.ssl-images-amazon.com/images/I/91H9TOVowCL._SL1500_.jpg (but hopefully with better looks!)
From a wood engineering standpoint I'd be in favour of looking into this. By using this method, wood movement with climate becomes negligible, which makes things a good deal easier there.
Artistic only: The burned edges are arguable in any logo cutouts, though less than optimal visually elsewhere (IMO). If laser-cutting, however, there is no choice, and the edges of a laser cut stack will exhibit the same burned look, just all in a band around the outside, rather than in scattered bits along the corners. The example on the Crowd Supply page appears to have been significantly sanded to minimize the burnt edges. This is a time consuming operation that will reduce the accuracy of edge alignment.
Any decent laser cutter can be used as a laser engraver to put (stopped) dadoes to hold PCBs anywhere you want them. You can also put a rabbet on any layer for the same purpose as needed in the layered option, so that isn't a serious obstacle. The only (minor) limitation with rabbets is that at the registration accuracy likely required, having a rabbet on both sides of a layer for different boards is probably unworkable.
Tor
...snip