30 May
2017
30 May
'17
8:45 a.m.
On Tue, May 30, 2017 at 5:09 AM, Tor, the Marqueteur Marqueteur@fineartmarquetry.com wrote:
On 29/05/17 16:56, Luke Kenneth Casson Leighton wrote: ...snip...
- Am I right that the front right corner actually only needs a single
wide dado on the inside face for the eject button?
yes.
- Do any of the components on the other three corners need cutouts,
no.
or are they back just far enough to clear?
yes.
Then, presuming I can find a router bit within tolerance for the height of the eject button, it looks like I could do this design as is for the corners.
if i thin down the parts on the inner edge i could potentially do away with the need for the eject button inset entirely.
i also want to bring out the PCB cut through to the front so that you can do a straight-through cut with a router @ around 1.8 to 2.0mm.
l.